Power hydraulics · 3 min read · Krzysztof Przewoźniak

A photorealistic scene of hydraulic end fittings, a quick coupling and a hose cross-section showing the bore.

DN12 is a nominal size designation used in hydraulics. It does not automatically mean that every bore, thread or hose measures exactly 12 mm. Check how the designation...

DN12 is a nominal size designation used in hydraulics. It does not automatically mean that every bore, thread or hose measures exactly 12 mm. Check how the designation is interpreted in the documentation for the particular component.

When selecting a hydraulic hose or a quick coupling distinguish nominal size from the actual inside diameter, outside diameter and thread size.

What does a nominal designation tell you?

DN identifies a size within a particular designation system. The number after DN is not itself a caliper measurement. Without documentation, it must not be substituted for the actual diameter in flow calculations.

Do not assume that every size used in hose or quick-coupling designations belongs to the same standardized series. The standard and data sheet for the particular product family determine this.

What should you measure or read before buying?

  • The full designation of the hose or connector and its manufacturer.
  • The actual hose inside diameter given in mm in the product data sheet.
  • The end-fitting type, thread size and pitch, and sealing geometry.
  • The operating pressure, medium and permissible temperature.
  • For a quick coupling, the series, mating-half profile and manufacturer's requirements.

DN12 and 1/2 inch — are they the same?

In hydraulic product listings, these descriptions may be used for the same commercial size, but that does not make DN12, a 12 mm bore diameter and a 1/2 inch thread size identical. Read the hose's actual inside diameter from its data sheet. Identify the thread separately.

For example, the Gates 8G2L catalogue hose in size 1/2 inch has a stated inside diameter of 12,7 mm. This is an example of a specific manufacturer's product. It does not confirm the specifications of every hose designated DN12 or state that it is available from NERON.

Does DN specify performance or pressure?

The DN designation alone does not specify permissible pressure, flow or full interchangeability. Pressure losses depend on factors including the actual cross-section, hose length, medium and resistance of the end fittings. A larger nominal size does not by itself guarantee higher performance of the complete system.

Typical hydraulic errors include selecting solely by the DN designation and overlooking pressure, sealing method or compatibility of quick-coupling halves.

Frequently asked questions

Does DN12 mean an outside diameter of 12 mm?

No. Do not identify the outside diameter or thread simply by copying the number 12.

Can any DN12 components be connected?

No. Confirm compatibility of the series, connection geometry, sealing and operating parameters.

How do you select a component at NERON?

Compare the full designation and data sheet for the particular variant. Quick couplings and Connectors must also be selected according to their design and operating conditions.

Loading...
Back to top