Bearings · 3 min read · Redakcja Neron piła

A photorealistic needle roller bearing without an inner ring, showing a row of slender rollers.

A needle roller bearing uses slender rollers. Identify its design before measuring it. It may be a bearing with an inner ring, one without this ring, a thin-walled dra...

A needle roller bearing uses slender rollers. Identify its design before measuring it. It may be a bearing with an inner ring, one without this ring, a thin-walled drawn cup or a needle roller and cage assembly alone. The different designs are not identified using the same set of measuring surfaces.

What do d, D, B and Fw mean?

  • d — bore diameter of the inner ring, if an inner ring is present.
  • D — outside diameter of the bearing or outer ring according to the drawing.
  • B or C — width specified for the particular design in the catalogue.
  • Fw — diameter under the needle roller set, relevant in particular to designs without an inner ring.

Do not equate Fw with the bore of a nonexistent ring or with an arbitrary caliper reading between loose needle rollers. Confirm the terminology and reference surfaces in the manufacturer's drawing.

Preliminary identification step by step

  1. After safely stopping the machine, read the designation and document the design. Secure loose needle rollers. Do not remove seals or the cage unnecessarily.
  2. Remove dirt from the measuring surfaces using a method approved for the design. Do not wash out factory-applied grease or alter protective features solely for a preliminary measurement.
  3. Check the tool and measure without excessive force. A caliper can help establish the approximate overall dimensions, but it does not replace tolerance and fit inspection.
  4. Read the outside diameter and width at the appropriate surfaces. Compare measurements taken at several positions and with the catalogue drawing.
  5. Check the inner-ring bore or Fw using the method appropriate to the type. Record the designation, seals and presence of an inner ring as well as the numerical values.

An important exception is the thin-walled drawn cup

Its unsupported ring may not yet have its final shape. SKF describes checking diameter Fw after fitting the bearing into an appropriate master ring, using a measuring mandrel. Simply measuring a removed cup with a caliper therefore does not confirm dimensional conformity or correct clearance after installation.

Are dimensions enough to select a replacement?

No. Also check the design type, load ratings, speeds, seals, lubrication requirements and the condition and requirements of the shaft raceway. In designs without an inner ring, the shaft may run directly against the needle rollers and must meet the manufacturer's requirements for material, hardness and finish.

What information should you provide when buying?

Prepare a legible designation, the manufacturer, a photograph or description of the design and dimensions indicating which surfaces were measured. If in doubt, also provide the machine designation or a drawing of the bearing arrangement. Do not select a replacement solely on a similar appearance or three arbitrary readings.

Loading...
Back to top