Bearings · 3 min read · Krzysztof Przewoźniak

An open ball bearing beside an inspection magnifier, notebook and callipers.

How to read bearing designations: a complete guide A bearing designation covers its type and dimensions as well as additional design information, such as seals or inte...

How to read bearing designations: a complete guide

A bearing designation covers its type and dimensions as well as additional design information, such as seals or internal clearance before mounting. A correct substitute requires comparison of the full designation and the manufacturer's catalogue; matching dimensions alone are not enough.


What does the designation 6205 mean?

The example designation

6205 2RS C3

consists of several elements.

6205 — bearing type and dimensions

  • 6 — single-row deep groove ball bearing,

  • 2 — dimension series,

  • 05 — bore diameter of 25 mm.

For many standardised bearings, bore codes from 04 to 96 are read as code × 5 mm. There are exceptions, such as diameters of 22, 28 and 32 mm written directly after a slash. Codes 00, 01, 02 and 03 mean 10, 12, 15 and 17 mm respectively. Always confirm the rule for the specific series.

Designation 

Inside diameter

04 

20 mm

05 

25 mm

06 

30 mm

07 

35 mm

08 

40 mm

09 

45 mm

10 

50 mm

What does ZZ mean?

ZZ means metal shields on both sides of the bearing.

Advantages:

  • protection against contaminants,

  • suitability for high-speed operation,

  • low rolling resistance.

What does 2RS mean?

2RS is a commonly used designation for seals on both sides. The material type, design and permissible conditions depend on the manufacturer and full suffix; not every seal has identical properties.

Advantages:

  • very good protection against dust and moisture,

  • protection dependent on the specific design and operating conditions,
  • factory lubrication.

What does C3 mean?

C3 means internal clearance greater than normal in the group to which the designation applies. It is not a quality or accuracy class. Selection requires checking the fits, temperatures of both rings and the required operating clearance after mounting.

Examples of equipment in which C3 may be found are listed below. However, the presence of a motor, pump or elevated temperature alone does not confirm that C3 is a suitable substitute.

  • in electric motors,

  • pumps,

  • fans,

  • equipment operating at elevated temperatures.


The most common seal designations

Symbol 

Meaning

Z 

metal shield on one side

ZZ 

metal shields on both sides

RS 

rubber seal on one side

2RS 

rubber seals on both sides

OPEN 

open bearing

The most common clearance designations

Symbol 

Meaning

C2 

reduced clearance

CN 

normal clearance

C3 

increased clearance

C4 

clearance greater than C3

C5 

clearance greater than C4

Designations of the most common series

Series 

Application

6000 

60 family — select using the specific catalogue

6200 

62 family — select using the specific catalogue

6300 

63 family — select using the specific catalogue

3200 

double-row angular contact ball bearings

3300 

double-row angular contact ball bearings; compare the specific size and C/C0

How do you select a replacement bearing?

The safest approach is to read the full designation on the old bearing. If it is illegible, measure:

  • inside diameter (d),

  • outside diameter (D),

  • width (B).

Dimensions d, D and B narrow down the selection. Before using a substitute, also compare its type, clearance or preload, seals, cage, load ratings, speeds and the mounting requirements of the specific design.

Summary

The full designation helps establish the correct bearing design but does not replace checking the machine requirements. Check suffix meanings in the manufacturer's documentation; do not select C3 or a seal based only on the equipment name.

Loading...
Back to top