Bush Taper Lock 1615/25 — Hubber

Bush Taper Lock 1615/25 — Hubber

Cast iron Hubber bush type 1615, shaft bore 25 mm, height 38,1 mm. Intended for drive components with a 1615 seat. The designation 1615 identifies the type, and 25 mm — the shaft bore.

Parameters

Selection and scope of offer

Check the seat type, shaft diameter and keyed connection. The offer includes one bush; the wheel is not included. Sales from 1 piece, fulfilment within 48 hours. NERON Piła — assistance with selecting drive parts.

Installation guidance for Taper Lock bush 1615

1. Before work, stop the drive, disconnect the power supply and secure the machine against starting.
2. Check compatibility of type 1615, the bush bore with the shaft diameter, and the keyed connection requirements. Clean the mating surfaces; do not install on a damaged shaft.
3. Seat the bush and wheel and install the screws in the mounting holes in the order specified in the instructions supplied with the Hubber bush.
4. Use a torque wrench and the torque specified by the manufacturer of the particular bush. If you do not have this value, obtain it before installation; do not tighten by feel.
5. Check wheel alignment, belt tension and guards according to the machine documentation. Remove the bush according to its instructions, without random impacts or excessive force.

These are brief selection and installation guidelines, not a replacement for the manufacturer instructions.

The own illustrative visualisation is shared by type 1615. The table specifies the bore diameter and dimensions of the particular variant; the image is not a dimensional photograph of this individual item.