Pulley SPZ 150/2 for Taper Lock 2012 — Hubber
The offer includes the pulley only. The bushing is not included and is sold separately.
Cast-iron Hubber SPZ 150/2 pulley with two grooves for a belt drive. Shaft mounting requires a separately selected Taper Lock bushing 2012. The bushing type does not indicate the shaft diameter.
Select a Taper Lock bushing for this pulley
Required type: 2012. Select the bore to match the shaft. Selected Hubber bushings are purchased separately; the tile opens the product page and does not add the product to the basket automatically.
The bushing price and availability are shown on its product page. These are three selected bores, not the full range for type 2012. The category for the full series may include different brands.
Dimensions and specifications
| Manufacturer | Hubber |
|---|
| Designation | TB SPZ 150/2 |
|---|
| Pulley profile | SPZ |
|---|
| Number of grooves | 2 |
|---|
| Datum diameter D | 150 mm |
|---|
| Outside diameter Da | 154 mm |
|---|
| Rim width B | 28 mm |
|---|
| Overall axial width | 32 mm |
|---|
| Bushing type | Taper Lock 2012 — sold separately |
|---|
| Material | Cast iron |
|---|
| Belt profiles | Z, HZ, ZX, SPZ, XPZ |
|---|
| Design | Solid pulley |
|---|
| OEM reference | ZT01502 |
|---|
| Weight of pulley only | 2,750 kg |
|---|
Selection and applications
Check the profile and minimum permitted pulley diameter for the belt being used, the transmission ratio, speed and drive load. Select bushing 2012 to match both the pulley seat and the shaft diameter. The pulley and bushing are ordered as two separate products. NERON in Pila helps select parts for industrial drives.
Taper Lock 2012 bushing installation guidance
- Before starting work, stop the drive, disconnect the power supply and secure the machine against starting.
- Check compatibility of type 2012, the bushing bore with the shaft diameter, and the requirements for the keyed connection. Clean the mating surfaces; do not install on a damaged shaft.
- Fit the bushing and pulley and install the screws in the mounting holes in the sequence specified in the instructions supplied with the Hubber bushing.
- Use a torque wrench and the torque specified by the manufacturer of the particular bushing. If you do not have this value, obtain it before installation; do not tighten by feel.
- Check pulley alignment, belt tension and guards in accordance with the machine documentation. Remove the bushing according to its instructions, avoiding uncontrolled impacts and excessive force.
These are brief selection and installation guidelines and do not replace the manufacturer's instructions.
The illustrative diagram shows D — datum diameter, Da — outside diameter and B — rim width. Numeric dimensions are listed in the table. Not for measurement or manufacture.
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent