Taper Lock bush 1108/22 — Hubber

Taper Lock bush 1108/22 — Hubber

Hubber cast-iron bush, type 1108, shaft bore 22 mm, height 22,3 mm. Intended for drive components with a 1108 seat. The designation 1108 specifies the type, and 22 mm the shaft bore.

Specifications

Selection and scope of offer

Check the seat type, shaft diameter and keyed connection. The offer includes one bush; the pulley is not included. Available from 1 piece, fulfilment within 48 hours. NERON Piła — help with selecting drive components.

Taper Lock 1108 bushing installation guidance

1. Before starting work, stop the drive, disconnect the power supply and secure the machine against starting.
2. Check compatibility of type 1108, the bush bore with the shaft diameter, and the keyed connection requirements. Clean the mating surfaces; do not install on a damaged shaft.
3. Fit the bush and pulley and install the screws in the mounting holes in the sequence specified in the instructions supplied with the Hubber bush.
4. Use a torque wrench and the torque specified by the manufacturer of the particular bush. If you do not have this value, obtain it before installation; do not tighten by feel.
5. Check pulley alignment, belt tension and guards according to the machine documentation. Remove the bush according to its instructions, without uncontrolled impacts or excessive force.

These are brief selection and installation tips, not a replacement for the manufacturer's instructions. Hubber selection and installation tips — supplier material.

The original illustrative visualisation is shared by type 1108. The bore diameter and dimensions of the specific variant are specified in the table; the image is not a dimensional photograph of this item.