Armack soldering grease flux 100g
Armack soldering grease flux 100g.
Flux 100 grams, intended for soft soldering various metals, primarily copper, brass, galvanised sheet and tinning sheet. Tin wire or rods can be used for soldering.
Physical and chemical properties:
Physical state: paste at 20°, liquid above the freezing point
Colour: yellow
Odour: slight mineral-oil odour
pH: 1,0 (aqueous solution)
Freezing point: 50-55°C
Initial boiling point and boiling range: no data.
Flash point: > 150°C
Evaporation rate: no data.
Flammability: non-flammable.
Upper/lower flammability or explosive limit: not applicable.
Vapour pressure (for zinc chloride): 1.33 hPa (428 °C).
Vapour pressure (for ammonium chloride): 0,13 kPa [20°C]
Vapour density: no data.
Relative density: approx. 900 kg/cm3
Solubility (at 20°C - water): < 10-² g/l
Solubility (at 80°C - white spirit): readily soluble.
Octanol/water partition coefficient: no data.
Auto-ignition temperature: not applicable.
Decomposition temperature: no data.
Viscosity: 6,0-9,0 mm²/s (at 100°C)
Explosive properties: not applicable.
Oxidising properties: no data.

Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent