Pulley SPA 75/2 for Taper Lock 1108 — Optibelt/Desch
The offer includes only the pulley itself. The Taper Lock bushing is not included; it is purchased separately.
Solid SPA 75/2 pulley with two grooves for an industrial belt drive, with an empty seat for bushing 1108. The bushing type determines compatibility with the pulley; select the shaft bore separately.
Sold from 1 piece, fulfilment within 48 hours. The price is for one pulley without bushing.
Select a Taper Lock 1108 bushing
Three selected bores are shown below. A tile opens a separate offer; it does not add the bushing to the basket automatically.
Check bushing price and availability on its card. The category for the entire type may contain different brands.
Dimensions and specifications
| Designation | TB SPA 75/2 |
|---|
| Pulley profile | SPA |
|---|
| Number of grooves | 2 |
|---|
| Datum diameter D | 75 mm |
|---|
| Outside diameter Da | 80,6 mm |
|---|
| Pulley width B | 35 mm |
|---|
| Required bushing type | Taper Lock 1108 — to be purchased separately |
|---|
| Design | Solid pulley, without bushing |
|---|
| Material | Cast iron |
|---|
| Belt profiles | A, HA, AX, SPA, XPA |
|---|
| Mass of the pulley alone | 0,600 kg |
|---|
| OEM code | AT00752 |
|---|
Selection and applications
Select belt profile, datum diameter, number of grooves, ratio and drive load. The bushing must be type 1108 with a bore matched to the shaft. Check the key connection, alignment and belt tension. NERON in Piła helps select power transmission components.
Taper Lock 1108 installation tips
- Stop the drive and secure it against starting. Check the condition of pulley, bushing and shaft, and compatibility of their designations.
- Clean and degrease the shaft and tapered surfaces of the bushing and pulley seat. Align the half-holes according to the instructions. Lightly oil the screws; do not lubricate tapered surfaces.
- Position the assembly on the shaft. If a key is used, maintain the required clearance above it. Check pulley alignment and tighten the screws evenly with a torque wrench.
- The Optibelt 1108 bushing uses two screws and a tightening torque of 5,7 Nm. For another brand's bushing, use its manufacturer's instructions; do not transfer the torque automatically.
- After approx. 0,5–1 hours of operation, stop and secure the drive, then check tightening torque, alignment and belt tension.
These are brief selection and installation tips, not a substitute for the manufacturer's instructions. Optibelt installation and maintenance instructions.
The main graphic and cross-section show a simplified solid two-groove pulley without a bushing. They are illustrative and do not show all mounting-hole details of the specific piece. Actual dimensions are specified in the offer table; the diagram is not for measurement or production.
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent